open access

Journal of Nanoscience and Nanomaterials

ISSN: 3108-2084 (Online)
DOI Prefix (Crossref): 10.67238

A Regenerable Nanomaterial-Based Continuous Filtration System for Persistent Water Contaminants
Research Article - Volume: 2, Issue: 1, 2026 (November)
Harsh Moralikrishna Panchal*

Independent Researcher, School of Engineering & Technology, Indira Gandhi National Open University, India

*Correspondence to: Harsh Moralikrishna Panchal, Independent Researcher, School of Engineering & Technology, Indira Gandhi National Open University, India, E-Mail:
Received: September 12, 2026; Manuscript No: JNNC-26-1041; Editor Assigned: September 18, 2026; PreQc No: JNNC-26-1041(PQ); Reviewed: September 24, 2026; Revised: October 05, 2026; Accepted: October 09, 2026; Published: November 13, 2026
;

ABSTRACT

Persistent water contaminants including per- and polyfluoroalkyl substances (PFAS), heavy metals, and pharmaceutical residues are difficult to manage because they occur across chemically diverse classes, may remain mobile at low concentrations, and can be accompanied by complex water-matrix effects. This article presents, a research and engineering framework for a contained, regenerable nanomaterial-based continuous-flow filtration platform. The concept integrates selective adsorption, immobilization of the active nanomaterial, breakthrough monitoring, regeneration, contaminant concentration, and reuse within one treatment cycle. Candidate material classes are screened according to adsorption capacity, kinetics, selectivity, mechanical stability, regeneration performance, nanoparticle retention, manufacturability, and cost. The proposed experimental programme progresses from material synthesis and characterization through batch adsorption screening, continuous-flow column testing, leaching assessment, regeneration, multi-cycle durability testing, real-water validation, and techno-economic analysis. Because the present manuscript is a research-development framework rather than a report of completed laboratory experiments, numerical performance values are treated as predefined development targets and are not presented as measured results. The principal research contribution is therefore the integration of material and process requirements into a single testable architecture designed to address the limitations of disposable adsorbents and uncontrolled nanoparticle release. The framework provides a basis for future laboratory validation and prototype development, while identifying the measurements required to establish removal efficiency, breakthrough behaviour, capacity recovery, durability, and safety.

Keywords: Nanomaterials; Water Treatment; PFAS; Heavy Metals; Pharmaceutical Residues; Adsorption; Continuous Filtration; Regeneration; Nanoparticle Leaching; Breakthrough Monitoring; Reusable Adsorbent


Citation: Panchal HM (2026). A Regenerable Nanomaterial-Based Continuous Filtration System for Persistent Water Contaminants. J. Nanosci. Nanomater. Vol.2 Iss.1, November (2026), pp:92-98.
Copyright: © 2026 Harsh Moralikrishna Panchal. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.